Skip to content

Carbon Fiber Mirror Covers

Carbon mirror covers change the visible outer face of the existing mirror assembly. Replacement caps take the place of the original cover, while thin overlays and upper trims fit over it. Left and right pieces are molded separately, with the appropriate fixing edges and indicator openings for each housing.

Detached handed pair of domed carbon fiber mirror caps with open lower rims and retained clip returns.

Paired replacement shells before fitting to their retained mirror housings.

Mirror cover options

Replacement cap with open lower rim

Replacement cap with open lower rim

This part replaces the original outer cap, with a domed face, open lower rim and clip edge shaped to engage the existing housing clips.

Thin overlay cap

Thin overlay cap

This thin carbon shell covers the existing mirror cap, following its outer curve and finishing at a defined edge band.

Cap with defined lamp opening

Cap with defined lamp opening

This cap has a long, narrow cutout sized to the existing indicator lamp, so the original lamp stays in use.

Partial upper-face trim

Partial upper-face trim

This part covers only the upper face of the mirror, ending at a clean edge line above the original lower housing.

Custom mirror cover pairs

Separate left and right molds

Each side is molded from your original caps, 3D scans or drawings, so each cover follows its own housing.

Housing and lamp details

Rim returns, retaining tabs and indicator openings are shaped to each housing, including any differences between the left and right sides.

Matching carbon faces

Weave direction and a gloss, satin or matte finish are matched across the pair.

Mirror-cap shape and retaining edge

Cap outline and lower openingCap span and face height describe the domed outer face. Height runs from the crown to the face's lower edge, excluding the lower rim return. The rim span is marked separately where the cover meets the mirror housing.Cap spanFace heightLower rim span

Cap outline and lower opening

Cap span and face height describe the domed outer face. Height runs from the crown to the face's lower edge, excluding the lower rim return. The rim span is marked separately where the cover meets the mirror housing.

Curved mirror cap with an open lower rim and two inward retaining tabs

Open rim and retaining tabs

The lower rim return and inward retaining tabs are placed to match the existing housing on each side.

All Carbon Fiber

Carbon Fiber Mirror Cover

Detached handed pair of domed carbon fiber mirror caps with open lower rims and retained clip returns.

Paired replacement shells before fitting to their retained mirror housings.