Carbon Fiber Side-Vent Trims
Carbon side-vent trims finish the visible edge of a fender vent. Separate left and right pieces can replace the original trims or cover them as thin overlays, with each contour and attachment edge matched to its vent carrier.

Handed carbon side vent trims showing the narrow woven face and underside with three clip tabs.
Image credit: ·
Side vent trim options

Narrow replacement trim pair
The left and right trims have slim faces, shaped ends and rear clip tabs that replace the original parts.

Defined overlay strip
This thin carbon strip fits over the existing vent surround, so the original trim stays in place.

Trim surrounding a retained opening
This narrow carbon frame outlines the vent opening while the original vent stays in place.

Carbon face with separate carrier
This carbon face clips to a separate vent carrier, so the visible face and the carrier are made and fitted as separate parts.
Side vent trim customization
Slim profile molding
We mold narrow carbon faces and returned edges to the profile of your vent surround.
Left and right contours
Each side has its own curve, end reliefs and clip positions, taken from the left and right fender references.
Matched surface appearance
The weave direction and surface sheen can be coordinated across the left and right pieces.
Narrow vent surround and clips
Trim size and clip-base spacing
The face view measures length along the trim and width across it. The underside view measures spacing between the two marked outer clip-base centers.

Open center and rear tabs
The open-center surround has rounded ends and rear tabs that clip into the existing vent carrier. The duct behind the vent remains a separate component.


