Skip to content

Carbon Fiber Seat-Back Decorative Covers

These decorative carbon covers finish the rear of an existing seat back. A continuous cap or separate upper and lower pieces follow the original trim's curves, with reliefs near the headrest and openings for retained pockets or access points. The seat structure and mechanisms stay beneath the covers.

Continuous contoured carbon seat-back rear cover with shoulder reliefs, a broad lower face and returned perimeter edges.

Continuous rear decorative cover with shoulder reliefs. We mold the contours and fixing edges to your existing seat trim; split upper-and-lower covers are a separate layout option.

Seat-back cover layouts

Upper and lower cover set

Upper and lower cover set

The separate upper and lower covers have shoulder reliefs at the top and a contoured lower face.

Continuous rear decorative cap

Continuous rear decorative cap

One continuous rear cover has turned edges and attachment areas around the perimeter.

Upper headrest-area cap

Upper headrest-area cap

This smaller cap covers the upper seat back near the headrest and leaves the lower edge open.

Lower rear cover with access opening

Lower rear cover with access opening

A pocket or access opening interrupts the lower cover where the original seat trim needs it.

Decorative covers made to your trim

Rear-cover molding

Rear-face curves and returned edges follow the original seat-back trim.

Reliefs, clips and openings

Shoulder reliefs, clip areas and access openings are placed where the original trim has them.

Matched surface appearance

Weave and surface sheen are matched between the upper and lower pieces.

Seat-back coverage and trim split

Upper and lower cover sizesThe upper and lower pieces are shown separately. Each height applies to one cover only, and width is measured across the upper piece.Upper cover widthUpper cover heightLower cover height

Upper and lower cover sizes

The upper and lower pieces are shown separately. Each height applies to one cover only, and width is measured across the upper piece.

Separate upper and lower seat-back trim covers with returned edges and clip-area references

Separate upper and lower covers

The two covers have returned edges and clip areas placed to suit the existing seat carrier.

All Carbon Fiber

Custom Carbon Fiber Seat-Back Covers

Continuous contoured carbon seat-back rear cover with shoulder reliefs, a broad lower face and returned perimeter edges.

Continuous rear decorative cover with shoulder reliefs. We mold the contours and fixing edges to your existing seat trim; split upper-and-lower covers are a separate layout option.