Drop Water Slide Sections
Fiberglass drop-slide sections form the crest, steep open descent and lower recovery curve of a water slide. We mold individual modules, including replacement crest pieces, to the complete riding surface in the approved ride design. Colors, flanges and support contact areas can match the adjoining sections.

Yellow steep fiberglass drop flume with a curved crest, recovery outlet and dark steel stair tower
Image credit: ·
Drop-slide section types

Crest transition
A rounded crest carries riders from the platform entry into the steep channel.

Steep open module
A straight, steep open channel has end angles taken from your route drawing.

Bottom recovery curve
A lower curve eases the descent into the exit channel.

Replacement crest section
A single crest section is made from drawings or measurements of an existing slide's sidewall and flanges.
Drop-slide section customization
Slide-profile molding
Crest, descent and recovery riding surfaces are molded to the profile in your ride elevation drawing.
Section connections
End angles, flanges and support contact areas are prepared to match the adjoining sections and the ride’s support design.
Channel colors
Colors carried through the steep run and curved transitions are matched across section joints.
Drop profile and recovery sections
Run length and height change
Horizontal run is measured from the start to the exit. Height change uses the same center-route reference at both ends. The crest span marks the horizontal extent of the upper transition; its full curvature remains defined by the ride model.

Crest, descent and recovery pieces
Crest, steep-channel and recovery sections are made as separate pieces and joined at the positions set in your route design.


