Open Flume Water Slide Sections
We mold fiberglass open-flume sections for water slides. Straight descents, banked bends and exit pieces follow the approved route, with flanged joints between modules and contact areas for the separate support structure.

Orange and turquoise open fiberglass slide modules descending a landscaped slope on steel supports.
Image credit: ·
Open-flume section options

Straight descending section
The straight channel follows the slope and sidewall height in the slide-route model.

Banked curved section
A curved channel has the bank angle, radius and turn direction taken from your route.

Jointed shipping modules
The route is divided into shippable modules, with flange joints at the break points you specify.

Exit transition
An exit section eases the slope to level for your pool or runout.
Open-flume sections made to your route
Straight runs and bends
Channel sections follow the slopes, curve radii and bank angles in your route model.
Joints and support contacts
The module ends have joint flanges, and underside contact areas align with the separate support structure.
Exit pieces and colors
An exit section is shaped for your pool or runout, with colors planned section by section along the route.
Open-flume route and channel section
Route reach, drop and clear width
The side profile marks horizontal reach and the height difference between the entry and exit riding-floor references. The section below marks clear chute width. Final geometry follows the approved slide-route model.

Open channel and returned edges
Each section has a curved riding floor and raised sidewalls. The edges project at each end to form the joint with the next section.


