Spiral Water Slide Sections
We mold fiberglass spiral-slide sections as open channels or enclosed tubes. The slide-route model sets each turn’s radius, bank angle and elevation; flanged ends join the sections in sequence on the separate support structure.

Blue enclosed fiberglass spiral slide with two descending turns, bolted section flanges, central supports and an open pool outlet.
Image credit: ·
Spiral-slide configurations

Single sweeping turn
A single wide turn follows the radius and bank angle in the route design.

Stacked spiral route
Successive turns sit one above another at the vertical spacing set by the slide-route model.

Enclosed spiral sections
Curved tube sections are joined along the shell seam and at ring flanges on each end.

Open spiral channel
An open channel follows the spiral bend, with its floor bank and sidewall heights set by the ride design.
Custom spiral-slide sections
Spiral surfaces
Curve radius, bank angle and turn elevations are molded to your slide surface model.
Section edges and joints
Sidewall profiles, tube-shell seams and end flanges follow the open or enclosed route design.
Route colors
Color bands and gloss level are planned around the turns.
Spiral-turn layout and molded bends
Spiral route and tube section
The route model defines centerline radius and vertical spacing between successive turns. A separate tube cross-section shows the clear bore; open-flume versions use the specified channel profile.

Open bend sections and end joints
Open curved sections have raised sidewalls and projecting end joints, so each piece lines up with the next around the spiral.


