Mat Racer Water Slide Lanes
We make fiberglass mat-racer lanes to suit your mats and the route profile in your ride design. The lanes run side by side with raised dividers and the same crest-and-dip profile, so riders race on matching runs, and each lane can have its own color.

Four fiberglass mat-racer channels in green, yellow, orange and red with raised white dividers and common roller profiles
Image credit: ·
Mat-racer lane sections

Open parallel lanes
Raised dividers separate the open channels as they run side by side.

Common roller profile
One crest-and-dip profile is repeated across every lane.

Launch lane mouths
Each launch mouth connects a lane to the start platform at its mat staging position.

Run-out lane sections
Run-out sections carry the lane floors and dividers on to the end of the ride.
Custom mat-racer lanes
Lane count and width
Parallel channels are sized to your mats, in the number of lanes your ride design calls for.
Crests, dips and exits
Matching crest-and-dip sections connect to separate start and run-out modules.
Lane colors
Each lane can have its own color or share a pattern across the set. Separate lane colors help riders and staff tell the lanes apart.
Racing lanes and shared route profile
Lane width, divider and rollers
The cross-section shows the clear width between lane walls and the divider height above the running floor. Roller spacing is measured between consecutive crests in the side elevation.

Parallel molded channels
The channels follow matching crests and dips. Their section joints align across the lane set.


