Skip to content

Railway Signal Equipment Cases

We mold fiberglass wayside cases to your signal mounting-panel drawing and surveyed foundation. Door arrangements, cable entry and the internal fitting space follow the installation and service layout, with a first case available for fit review before repeat supply. Signal equipment and railway-system acceptance remain within your equipment program.

Empty broad gray GRP cabinet with open double doors, black seal rim and internal mounting frame

Full-width equipment bay, outward-opening doors, seal rim and mounting back.

Railway signal case styles

Broad double-door case

Broad double-door case

Two doors open the full width of a wide mounting panel, with shorter leaves that need less swing space.

Single-door narrow case

Single-door narrow case

A slim single-door case houses a compact panel and opens for service from the front.

Double-sided service case

Double-sided service case

Front and rear doors let technicians reach the panel and the cable terminations from separate sides.

Plinth and cable base

Plinth and cable base

A raised plinth base fits the existing foundation and brings incoming cables up into the case.

Custom trackside case manufacturing

Case and door molding

Roof, door frames and base sections are molded to the panel size, with reinforced areas for panel mounting and foundation anchors.

Cable entries and hardware

Cable entries and vent openings are cut to your layout, and the doors, locks and stays you specify are fitted to the case.

Casing surface appearance

Exterior color is matched to your sample, with finished edges at the cable entries and support surfaces inside for the panel.

Trackside cabinet and cable fit

Panel bay, cable opening and plinthThe front elevation shows the clear panel bay with its doors omitted and the cable-entry aperture below it. The separate plinth plan marks two fixing-hole centers; the shown spacing runs front to back. Gland plates and cables determine the usable entry space.Clear panel bay widthPlinth fixing spacingCable-entry width

Panel bay, cable opening and plinth

The front elevation shows the clear panel bay with its doors omitted and the cable-entry aperture below it. The separate plinth plan marks two fixing-hole centers; the shown spacing runs front to back. Gland plates and cables determine the usable entry space.

Wide rectangular signal equipment cabinet with paired doors and the right door open to the empty panel bay

Wide two-door equipment bay

Paired doors open the full width of the bay while keeping each door leaf short, which helps where space beside the track is tight.

All Industrial FRP

FRP Railway Signal Equipment Case

Empty broad gray GRP cabinet with open double doors, black seal rim and internal mounting frame

Full-width equipment bay, outward-opening doors, seal rim and mounting back.