Skip to content

FRP Filtration Unit Covers

Custom fiberglass outer covers give a filtration skid a finished exterior while leaving the filter-change route accessible. Hood sections fit around connected pipework and can lift off or open individually for servicing. We mold the joining rims, reinforce the specified latch and lifting areas, and finish the set in your chosen color.

Cream-white two-piece equipment hood with roof ridge and lower latch

Removable front hood, stepped joining rim and outward mounting flange.

Filtration cover access options

Removable front hood

Removable front hood

A removable front hood clears the filter-change route while the rear casing stays in place.

Lift-off upper cover

Lift-off upper cover

The upper cover lifts straight off the unit when maintenance is done from above.

Hinged service lid

Hinged service lid

A hinged lid opens above the unit and stays attached while filters are serviced.

Split pipe-entry cover

Split pipe-entry cover

The cover splits into sections around fixed pipework where a one-piece hood cannot lift clear.

Filtration cover construction

Removable sections

Hood sections are molded with mating rims, and the fastener and lifting points you specify are reinforced.

Pipe openings

Openings for fixed pipes and drainage reliefs are cut to line up with the section joints and the direction each section is removed.

Edges and gelcoat

Pipe-opening edges and latch contact areas are finished, and the gelcoat is applied in your chosen color and gloss.

Filter access and pipe fit

Service opening and pipe diameterThe front view measures the service opening between its opposing edges. The separate circular detail shows the pipe-opening diameter. These opening dimensions do not establish the complete filter-withdrawal space, which depends on the element length, removal direction and cover movement.Service opening widthService opening heightPipe opening diameter

Service opening and pipe diameter

The front view measures the service opening between its opposing edges. The separate circular detail shows the pipe-opening diameter. These opening dimensions do not establish the complete filter-withdrawal space, which depends on the element length, removal direction and cover movement.

Split filtration cover with a separated front hood, side round pipe opening and flanged lower edges

Separate hood sections

A removable front hood, rear shell and side openings let the casing come apart around connected pipework. These components form the equipment exterior; the filtration vessel and process-pressure boundary are specified separately.

All Industrial FRP

FRP Filtration Unit Cover

Cream-white two-piece equipment hood with roof ridge and lower latch

Removable front hood, stepped joining rim and outward mounting flange.