FRP Laboratory Fume Hood Shells
We mold empty fiberglass fume hood shells to fit the selected sash, liner and worktop. Sash-guide areas, the roof extraction collar and side utility openings follow the assembly layout; airflow and containment depend on the complete hood and exhaust system built around the shell.

Fume-hood shell showing the sash opening, roof duct collar and worktop return. Sash, liner, worktop and extraction equipment follow the separately agreed assembly scope.
Image credit: ·
Laboratory hood shell options

Vertical-sash front
Parallel guide areas on each side of the opening accommodate a vertically sliding sash.

Wide service opening
A wide front opening accommodates horizontally sliding or combination sashes.

Rear utility space
A separate rear zone keeps your service lines and extraction connections behind the working bay.

Benchtop lift-off shell
A compact shell sits on the worktop, with an upper section that lifts off for access.
Fume hood shell customization
Shell molding
The casing and worktop return are molded with reinforcement where the sash guides and casework attach.
Collar and service openings
Duct collars and utility openings are trimmed to your drawing, with mounting areas ready for the guides and liner you specify.
Inner and outer surfaces
The reagent-facing resin or separate liner is selected for the intended chemical and cleaning duty. Exterior color and gloss follow the finish specification.
Sash opening and extraction collar
Sash opening and collar position
The front elevation measures the full shell opening width and height. Collar offset runs from the left outside edge of the shell to the collar centerline; the selected sash guides, operating travel and liner require their own fit checks.

Sash guides, roof collar and utility holes
The open front has sash-guide areas on both sides, with a round duct collar on the roof and utility holes in the side walls placed to your assembly drawing.


