FRP Marine Electrical Cabinets
We mold empty fiberglass cabinets for vessel bulkheads or dock pedestals, ready for your electrical panel to be fitted. Doors, cable-gland openings and drip returns are made to your layout; ingress protection depends on the gaskets, glands and latches used in the finished assembly.

Closed door, two separate latches, deep enclosure wall and returned front rim.
Image credit: ·
Marine cabinet options

Bulkhead cabinet
Rear tabs fix the empty cabinet to a vessel bulkhead or dock support.

Pedestal cabinet
The cabinet base provides fixing and cable-entry areas for mounting on a separate pedestal.

Drip canopy
A projecting canopy return over the door edge is shaped to shed rain from the top of the cabinet.

Twin-door panel bay
Two front doors divide a wide panel bay so each leaf needs less swing clearance.
Marine cabinet manufacture
Body and mounting
The cabinet body has rear fixing tabs or a reinforced base to suit the support. The door is molded to fit its returned front rim.
Gland and hardware prep
Cable and drain openings are trimmed, with mounting areas prepared for the hinges, latches and backing plates you specify.
Surface appearance
The exterior can be finished in the specified color and gloss. Cable-entry edges are finished, and the inner surface follows the required cleaning conditions.
Cabinet bay and mounting
Equipment bay and cable zone
The open-body front view shows the clear bay width, the vertical pitch between the two fixing holes and the lower cable-entry zone. Their positions can be adapted to a vessel bulkhead or dock support.

Returned door rim and bottom entry
A recessed door rim, latch mounting areas and a lower cable entry are prepared for the glands and hardware you specify.


