Skip to content

FRP Pump Station Enclosures

Our molded FRP shells enclose pump skids, with lift-off, split-shell or door-access designs for servicing. Pipe and cable openings fit around the station's fixed connections. Pumps, process piping and skid supports are specified separately.

Deep-green tapered equipment hood with central raised band, front latch and flanged red base

Closed removable hood, central stiffening band, locking contact and perimeter base flange.

Pump enclosure access styles

Lift-off equipment hood

Lift-off hood

The whole upper shell lifts off for open access where a crane or hoist is available.

Split clamshell access

Split clamshell

Two hood sections separate around fixed services to expose the pump skid.

Door-access pump bay

Door-access pump bay

A service door opens the pump bay while the main roof stays fitted.

Pipe-entry end section

Pipe-entry end section

A separate pipe-entry panel can remain around the connected pipework while the main hood is removed.

Custom pump enclosure manufacturing

Reinforced shell molding

Hood and door sections are molded to the pump layout, with extra reinforcement at the base and at lifting points.

Pipe and service fitting

Pipe openings, cable passages and section joints are cut around the fixed services and the route needed to remove equipment.

Edges and paint coating

Base edges and mating faces are finished for a clean fit, with drain openings and exterior paint in your chosen color.

Pump hood and fixed pipe fit

Service opening, pipe center and fixingsThe left elevation shows the service aperture with its door omitted and two marked fixing centers in the base flange. The right end view locates the pipe opening center above the base contact plane. Enclosure fixings are separate from the pump-skid supports.Service opening widthPipe center heightBase fixing spacing

Service opening, pipe center and fixings

The left elevation shows the service aperture with its door omitted and two marked fixing centers in the base flange. The right end view locates the pipe opening center above the base contact plane. Enclosure fixings are separate from the pump-skid supports.

Ribbed arched pump-station hood above a separate base rim, with a detached end panel containing a round pipe opening

Lift-off hood and separate end panel

The ribbed upper shell, removable end panel at the pipe entry and base rim are shaped around your pumps and fixed lines.

All Industrial FRP

FRP Pump Station Enclosure

Deep-green tapered equipment hood with central raised band, front latch and flanged red base

Closed removable hood, central stiffening band, locking contact and perimeter base flange.