Skip to content

Valve Station Covers

We mold fiberglass covers for valve stations, with access arranged around fixed pipework. Options include a lift-off hood, a local operating hatch and split ends that close around the pipes. Raised pockets can provide clearance for actuators.

Low white fiberglass cover with raised roof ridge, square vent, lift handles and flanged base

Removable upper hood, defined horizontal joint, service handles and end ventilation panel.

Valve station cover styles

Lift-off station hood

Lift-off station hood

A lift-off hood opens the whole station from above for servicing.

Operator access hatch

Operator access hatch

A local hatch above the handwheel or actuator gives access for routine operation.

Split pipe-entry ends

Split pipe-entry ends

Removable split ends close around pipes that remain in position.

Raised actuator pocket

Raised actuator pocket

A raised pocket in the hood clears the actuator and its movement.

Valve cover molding and finishing

Hood and pocket molding

Hood profiles and actuator pockets are molded with reinforced areas for handles and base fixings.

Removable section fitting

We trim the operator hatches, split pipe entries and drain openings to the layout, then fit the specified latches and fasteners.

Gelcoat and edge surface appearance

We apply the chosen outer gelcoat color, seal cut edges and finish joint surfaces around removable sections.

Valve cover and pipe openings

Pipe fit and actuator clearanceThe end view marks the pipe-opening diameter. The side section shows the gap above the actuator and the service-opening width. The arrangement is checked against the fixed pipework and the access needed for each station.Pipe openingActuator clearanceService opening

Pipe fit and actuator clearance

The end view marks the pipe-opening diameter. The side section shows the gap above the actuator and the service-opening width. The arrangement is checked against the fixed pipework and the access needed for each station.

Pitched valve-station hood with a split end around a circular pipe opening and two short side vent slots

Split pipe end and side slots

The pitched hood has a split end that closes around the pipe, with short side slots for ventilation.

All Industrial FRP

FRP Valve Station Cover

Low white fiberglass cover with raised roof ridge, square vent, lift handles and flanged base

Removable upper hood, defined horizontal joint, service handles and end ventilation panel.